Process of sanitary cotton sliver production line

A processing process for forming a sanitary cotton sliver production line consists of the following steps: a continuous fiber mesh is basically cut on its width to form a cotton mesh part, which is connected to the continuous fiber mesh through multiple extension parts; Pull the cotton mesh apart from the continuous fiber mesh, tear open the uncut extension, and form a separate cotton mesh; Separate cotton webs form semi-finished sanitary cotton strips; Then, the semi-finished sanitary tampon is compressed to form a sanitary tampon.
Female sanitary tampons and their processing technology and equipment:
A sanitary cotton strip with a certain length, including: a). The width of a non-woven fiber mesh with a specific length corresponds to the length of a sanitary cotton strip and has a longitudinal axis. The end of the nonwoven fiber mesh is formed by a reduced cross-sectional area, and the end edge of the end is formed by alternating segments of cut fibers and extended fibers. In the alternating section, the cut fiber section is approximately 70% of the width of the nonwoven fiber section; b) A covering section, thermally bonded to one end of the non-woven fiber section. The covering section is composed of liquid infiltration, at least partially composed of thermoplastic materials, extending beyond one end of the non-woven fiber section; c) Once the rope is pulled out, it will extend from the tampon; Among them, the non-woven fiber mesh segment is basically wound on its own to obtain a roughly cylindrical semi-finished sanitary tampon preform. It has a cover segment that extends to one end of the non-woven fiber mesh and is bonded to an overlapping part of the cover segment, thereby maintaining the cylindrical shape of the sanitary tampon preform. The radial compression of the cylindrical preform forms a roughly cylindrical compressed sanitary tampon.
A production process for sanitary cotton strips and cores, characterized by the following:
1. Select high-quality nanofibers, fully dry them in the sun, use wild mugwort leaves, remove impurities and coarse stems, wash them, and fully dry them in the sun;
2. Weigh fixed weight nanofibers and mugwort leaves in proportion, press the nanofibers into a strip like nanofiber layer, mix mugwort leaves with the strip like nanofiber layer, and spray surfactants;
3. Wrap the mixed nanofiber layer tightly with non-woven fabric and spray antibacterial agent to form a cotton strip;
4. Grind raw Aconite, motherwort, Angelica sinensis, and Coptis chinensis evenly into powder, mix them into a solution, and apply them on the surface of the cotton strip to form an antibacterial layer;
5. Use an antibacterial layer for high-temperature sterilization of cotton strips;
6. Cotton strips are packaged under sterile conditions, i.e. finished products.